Installing CW LMS 3.1 in 2 servers

[luciana.obregon]

I have two servers with the following characteristics:

Server 1:

Windows Server 2003 - SP1

Pentium III 1133 MHz

3.00 GB of RAM

Server 2:

Windows Server 2003 - SP2

Dual 3.16 GHz Intel Xeon(R)

3.84 GB of RAM

I first installed all the CW applications in Server 2. The server was extremely slow and some of the applications would not even open (CiscoView)

I then installed CS, CM and RME on Server 2 and CS, IPM, DFM, CiscoView on Server 1. Server 2 is working fine but Server 1 is not. The processor utilization is almost 100% most of the times.

What is the best way to distribute the CW applications given the servers I have?

[Joe Clarke]

Server 1 is unsupported. LMS will not work there.

Server 2 should be sufficient to run all applications, and allow you to manage quite a few devices (at least 1.5K). What operations were slow? What processes were taking the most CPU? How many devices were you trying to manage?

[luciana.obregon]

Thanks for your reply.

All the applications were slow on Server too, when I installed the whole bundle. We have 304 devices that we manage.

CiscoView did not work at all. It took forever to load the page but never came up.

Now I am trying to re-install everything back on Server two.

[Joe Clarke]

Was this server integrated with ACS?

[luciana.obregon]

No, it is not integrated with ACS