INVALID INPUT DETECTED USING CONFIG TERMINAL COMMAND

[crismartc44]

Hello, someone can help me .
to set the ip of the router i need to go in configure terminal
i already try

conf t

config terminal

configterminal

configure terminal

its not working, it say invalid input

my ap model is AIR-AP1832I-A-K9

[crismartc44]

im just following this instruction 

How to configure standalone Cisco access point from GUI and configure WPA2 authentication - YouTube

but i cant proceed in configure terminal because i got an error 

[Ben Walters]

It looks like the AP might be running the lightweight software. 

If you run the command show version | include image

The image name of the standalone version contains k9w7 - this is the one you want.

The lightweight version contains k9w8. - If this is the case you would need to download the standalone software and install it on the AP.

If you are running the standalone version then it might be the AP type setting. Can you run the command ap-type mobility-express? If that is successful the AP should reboot into standalone mode. 

[crismartc44]

thanks for the reply, i'll try to download the standalone software.

i can access mobility express but i can't access the URL ip, i set it as static

[crismartc44]

Should I use mobility express?

[crismartc44]

i cant access the mobility express in the URL using this mobilityexpress.cisco or the IP i set for AP. 
I'm new in AP, please help me. thanks

[crismartc44]

what is the next step sir? i want to access the ap in URL

[Ben Walters]

Do you see the AP broadcasting a wireless network called CiscoAirProvision? 

The default password is password. 

If you see that network and are able to connect you should be redirected to mobilityexpress.cisco, if you aren't redirected, you can also go there manually or use the IP address 192.168.1.1

This is all from the config guide here:https://www.cisco.com/c/en/us/td/docs/wireless/access_point/mob_exp/83/user_guide/b_ME_User_Guide_83/b_ME_User_Guide_83_chapter_01000.html