Solved: [IOS XE] Netflow for PPPOE

anas.abdullkarim · ‎09-01-2022

Hello,

we have router ASR1006 with ESP100 for IPv4 NAT

we used it for the PPPOE session,

I looking to enable NetFlow for PPPOE session output

so I need to analyze traffic after NATing

BNG(config)#interface Virtual-Template100

BNG(config-if)#ip flow monitor FLOW_MONITOR_SAS output
% Flow Monitor: Failed to add monitor to interface: Virtual Interface Unsupported

marce1000 · ‎09-02-2022

- Ref : https://bst.cisco.com/bugsearch/bug/CSCsx24985

Symptom: Netflow on Broadband sessions of any type not supported on the ASR1000 platform. This includes: - virtual-template interfaces - ISG / layer 3 sessions - PPPoE / layer 2 sessions

M.

-- Each morning when I wake up and look into the mirror I always say ' Why am I so brilliant ? '
When the mirror will then always repond to me with ' The only thing that exceeds your brilliance is your beauty! '

View solution in original post

marce1000 · ‎09-01-2022

- FYI : https://bst.cisco.com/bugsearch/bug/CSCsx24985

M.

-- Each morning when I wake up and look into the mirror I always say ' Why am I so brilliant ? '
When the mirror will then always repond to me with ' The only thing that exceeds your brilliance is your beauty! '

anas.abdullkarim · ‎09-02-2022

Hello so is not supported or Bugs?

marce1000 · ‎09-02-2022

- Ref : https://bst.cisco.com/bugsearch/bug/CSCsx24985

Symptom: Netflow on Broadband sessions of any type not supported on the ASR1000 platform. This includes: - virtual-template interfaces - ISG / layer 3 sessions - PPPoE / layer 2 sessions

M.

-- Each morning when I wake up and look into the mirror I always say ' Why am I so brilliant ? '
When the mirror will then always repond to me with ' The only thing that exceeds your brilliance is your beauty! '