LAN MapShot Between VLAN's

[aalhajjah]

Hello,

I am trying to discover our network using LAN MapShot and we have VLAN's. I am not able to discover devices on the other VLAN's. Do you know how I could do that?. I can see snmp traffic going through the router, but not sure what's causing it. Before, we were on one subnet and I could discover all devices.

Thanks.

Aiman

[milan.kulik]

Hi,

have you tried using SNMP community strings indexed by VLAN, i.e. your_community@10 for VLAN10, e.g?

See

http://www.cisco.com/warp/public/477/SNMP/camsnmp40367.pdf

for details.

Regards,

Milan

[aalhajjah]

Hello Milan,

Thanks for the info, I did not know about it, but I tried it and still not discovering. I switched one PC into anoterh vlan and run the discovery there and it discovers only within its vlan as well.

Any other good hints.

Thanks.

Aiman

[lchance]

I have tried the same thing on the network at my location and it does not work.

I spoke to the vendor at Fluke and the person I spoke with said it does not cross over any segments. It (PC with the software) has to be physically moved around to get the network mappings.

Larry

[aalhajjah]

Larry,

Thanks for response. So, I will have to go to each vlan and discover there and then connect the pieces together.

Thanks,

Aiman