LMS 3.1 HUM 1.1.2 Port missing in interface utilization report

[sridharan26]

Dear,

We have configured a poller to fetch instance of interface availablility and interface utilization report for Cisco 6506 switch.

But the port is missing in Interface utilization but the same is shown in interface availability report.

Please check and revert in case any bug points to this sort of issue.

Thanks in advance,

Shridharan N

[Joe Clarke]

Try splitting your templates into individual pollers (i.e. one poller for utilization and one for availability).  If you then see a problem with missing utilization, check the status of the poller to make sure there are no errors.