LMS 3.2.1 State changes viewable via Topology Services

[gaboughanem]

Hi,

i was wondering if there is any way to configure the topology diagram to auto refresh.

every time i need to update the diagram i have to close the application and open it again OR i have to do "Perform Data Collection" and press "refresh map".

For Example if a switch or a link is down i won't give a red link or device until i manually refresh the page. i have also reduced all polling intervals

in the DFM to 60 sec.

Has any body encountered this kind of problem?

Thank you  and Regards,

George

[Joe Clarke]

This is a known issue, and development is working to isolate the root cause.  They have recently been able to reproduce the problem locally, so hopefully a fix will be available soon.  I recommend you open a TAC service request so you can be kept apprised of the status.

[gaboughanem]

Thank you Jo.

BR,

George