Hello,
I need a help:
I installed the Cisco LMS 4.0.1 (test mode), and monitoring services of the switches (data collection and information system) are working.
But when I need to apply some configuration via CiscoView settings are not applied.
The following message is displayed when I try to apply some configuration on an interface of any one switch.
"
Message
Timeout on 172.20.1.10.
This error could be due to lack of access to the host, invalid SNMP credentials, or a busy device.
To correct the problem, do one of the following:
- Verify access to the host.
- Check the SNMP credentials.
- Increase the timeout value through the preference options on the chassis view."
I've checked the credentials and SNMP communities, the problem continues.
Any idea?
Tks!
Marcos