LMS 4.0.1 : Workflow VLAN assignment issue on VSS and 3750
I'm running on LMS 4.0.1 with latest update and upgrade package (not the lms 4.1).
I have : VSS running on 12.2(33)SXJ1
and 3750x running on 12.2(58)SE2
When I try to perform some VLAN Port assignment change, I cannot do it through the Workflow :
Config > Workflow > VLAN > Config port assignment
When I click on the VSS and then "List ports", the list of the ports is clear ! The VLAN list is correct.
When I click on the 3750 and then "List ports", the list of the ports is complete, BUT the VLAN list is incorrect, with this kind of VLAN list :
What could be the problem ?
By which way can I easy change port vlan assignment and see what's the port status at the same moment ?
By the way, in CiscoView : is it also normal that I cannot change configuration of port that are not wired-connected on the switches ? Gi1/0/10 is connected and I can change POE, etc...but the Gi1/0/5 is not plugged and I have only physical information of the link.
Attached policy provides CLI access to the Cisco 4G router over text messaging. Two files are in the attached .tar file:
2. PDF with instructions on how to load and use the .tcl file.
Introduction to SD-Access Multicast
The document describes the Cisco DNAC UI workflow introduced as part of the Cisco DNA Center1.3.3 release. The document covers the components of Multicast forwarding on SD-Access fabric and the configuration pushed to...
Coming soon - Be the first to know about the New Product/Release Series. Join Customer Connection to register for the briefings throughout the month of October!
Membership in the Cisco Customer Connection program is required to attend. Registra...