Network Management

Hi Guys,I have a similar challenge to the one below :https://supportforums.cisco.com/thread/2001372?tstart=0But the only difference is that mine only shows:INFO: You must accept this License Agreement to proceed with the installation.INFO: If you ent...

I have a question.If i have a SNMP configuration in a switch 4510r, is there any posibility to reach the snmp server without the community command and without the server snmp command??????I have only this lines on the configuration.THANKSSS.snmp-serv...

Dear all,I've recently upgraded our CW 3.2 to 3.2.1 and I'm having a strange issue with HUM application registration with ACS. The privileges options such as 'Super Admin' etc are no longer there! All the privilege options for all of the other LMS co...

How can the command "show ip cache flow" help me troubleshoot network traffic problem, especially pinpointing a node hogging the bandwidth? Is there another command(s) I can also use?

I have just started to discover the power of EEM and am already monitoring config changes on our switches with EEM.I would like to be notified of any interface going up and possibly down. on our 6509's and 3750's This is just to be aware of anyone pa...

We have a Service Policy rule setup on our 5510 for SMTP traffic.outside-class1 1 True Match EMAILSIGServer any tcp/smtp class outside-class1police input 1024000 1500 conform-action transmit exceed-action droppolice output 1024000 1500 conform-action...

When pulling information through Campus Manger, User Tracking and pulling Device or Device Name for IP Phones, the following error is generated."Application error: SQL Anywhere Error -143: Column 'DeviceName' not found.". All othe functions work.Any ...

Hi!I´m searching for a  way to change duplex-mode and Port-Speed on IOS Routers 871 and 1811 via SNMP. I have OIDs for read-only-access but i did not succeed in  setting the values. Do you know the right way/OID?Thanks a lot for your help!

HiWe have installed CSM and RME +  MCP and are going to use RME now Does anybody using the 4 "user defined fields" at Common Services ?If yes , which data do you write to the fields ? sincerley Alfred

I am trying to monitor routers Cisco 2610, 2801 and 1760 with a monitoring software called zenoss. and I cant see on this devices the powersupply state, temperature sensor, fan state, i dont know if this models of routers cant support the monitoring ...

HiCould you help me with this problem- Data> IOS 12.4(15)T13- EEM configCONFIG-SET+---------------------------------------------------------------------------------------event manager applet TEST trapevent syslog pattern "%SYS-5-CONFIG_I:"action 1.0 ...