Hi all,
we discovered a problem with accuracy of SwitchPort Summary Reports im LMS 4.1.
The amount of shown Total and connected ports in reports is greater than displayed on Device-CLI.
Has anybody else discoverd same problems with these reports? Any suggestions?
Thanks -- Lothar
------
Follwoing output is a Cat4500 with 12.2(46)SG
(1) Ports counted on Device-CLI = 56
SWITCH1>sh mod
Mod Ports Card Type Model Serial No.
1 2 Supervisor IV 1000BaseX (GBIC) WS-X4515
2 6 1000BaseX (GBIC) WS-X4306-GB
3 24 10/100/1000BaseT (RJ45) WS-X4424-GB-RJ45
4 6 1000BaseX (GBIC) WS-X4306-GB
5 18 1000BaseX (GBIC) WS-X4418-GB
(2) Ports given by SwitchPort-Report = 60
/opt/CSCOpx/campus/bin/ut -cli -switchPortSummary -devices SWITCH1
Device Name,IP Address,Connected Ports,Free Ports,Free Down Ports,Total Ports
SWITCH1,10.192.209.47,50,3,7,60
(3) Several Ports a duplicate in Connected Ports Details
Port Port Name Oper Status Admin Status
Gi1/1 XXXX2001_G1/13 UP UP
Gi1/1 XXXX2001_G1/13 UP UP
Gi1/2 XXXSW153_G0/13, xxxxxxxxxxxxx UP UP
Gi1/2 XXXSW153_G0/13, xxxxxxxxxxxxx UP UP
Gi2/1 XXXSW30_G0/1, xxxxxxxxxxxxxxxx UP UP
Gi2/1 XXXSW30_G0/1, xxxxxxxxxxxxxxxx UP UP
