10-03-2013 09:54 AM
Hi!
I started to add new device MDS to LMS (v.4.2.4, soft appliance) - all works normaly (syslog messages arrive, configuration is going, faults come - a screenshot "lms_mds_03102013.JPG" in attachment).
1) Can somebody knows - device MDS (9506, 9506, 9513) supports in CiscoView (LMS 4.2.4)?
For example, as Nexus 5000 (as screenshot "lms_n5k_03102013.JPG" in attachment)?
2) And why not graphs (no data) on "Memory Utilization" and "Environmental Temperature" (for "CPU Utilization" data is collected, graphs are drawn) ?
Sincerely,
Andrey
Solved! Go to Solution.
10-04-2013 09:42 PM
Hi Andrey,
Cisco view is Not supported for MDS switches:
Thanks-
Afroz
[Do rate the useful post]
10-04-2013 09:42 PM
Hi Andrey,
Cisco view is Not supported for MDS switches:
Thanks-
Afroz
[Do rate the useful post]
10-08-2013 01:25 AM
Hi Afroz!
Thank you for reply and link! You always give accurate and precise answers!
And the second part of my question (for chart data "Memory Utilization" and "Environmental Temperature")?
Sincerely,
Andrey
10-08-2013 02:55 AM
Hi Andrey,
for this you need to create Poller in HUM [ Monitor > Performance Settings > Setup > Pollers ]
check the below link for more information:
I have also attached one screen shot
Thanks-
Afroz
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: