12-26-2012 07:58 AM
Hi,
If I have understand correctly, the IP address - mac address matching was made with the arp table of a cisco acces switch if it will made the L3.
My access switch wasn't used for L3 routing, only L2
It's possible to set user track to use the arp table of a firewall or a router for made this matching ?
Thanks a lot
Solved! Go to Solution.
12-26-2012 08:17 AM
As long as you have a supported Cisco Layer 3 device in your LMS-management domain, you should be able to correlate the IP-MAC addresses in User Tracking (UT).
UT support is not specifically listed for the ASA firewall - I'm not sure it will support that feature if it is the users' gateway.
Useful links:
UT explanation from the LMS Admin Guide
Hope this helps.
12-26-2012 08:17 AM
As long as you have a supported Cisco Layer 3 device in your LMS-management domain, you should be able to correlate the IP-MAC addresses in User Tracking (UT).
UT support is not specifically listed for the ASA firewall - I'm not sure it will support that feature if it is the users' gateway.
Useful links:
UT explanation from the LMS Admin Guide
Hope this helps.
12-28-2012 06:50 AM
thanks a lot marvin
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide