However, I have no idea what sub-commands might be used to specifically create an inventory collection job (I've never seen it done before), and I would be very wary of proceeding further without knowing what you might be getting into! :-)
Maybe someone else will chime-in here that knows how it could be done.
Hi Guys, I have two questions about EIGRP behavior when we have Multiple EIGRP routes: 1- I tried to show on some router the acquired EIGRP paths for a route X.X.X.X by typing the command : "show ip eigrp topology X.X.X.X". On the output there w...
[ The Discussion forum will be published on December 1st ]
Take the opportunity to reach out to our expert and discuss best practices regarding on how to troubleshoot a live network and identify the root cause easily. Learn more about Serviceability and h...
To provide a solution to quickly setup a router at a remote location that supports WiFi and provides instant internet access using LTE as a transport while deploying with Cisco SD-WAN.
Plug the router to a power sou...
Hello!I'm looking for a way to make my EEM script more dynamic and automated for my environment. This is what I have - basically I just capture the 4 IPSec peer IP addresses of each neighbor and insert this data into 4 different variables. ...
Hi all,I have a couple of Nexus9k switches. I need to get tcpdump from the physical interface which connected to the server. I'm looking for a specific protocol on tcpdump so that which feature should I use? I asked that because I couldn't full...