03-05-2010 11:28 AM
Hi,
I would like to get an information about gigaStack port on switch inventory.
I have generated an Detail device Report but I didn't get this information.
I can find this information by show interface status | include GigaStack on switch :
Gi0/1 connected trunk a-full a-1000 1000BaseCX Gigastack
Gi0/2 connected trunk a-full a-1000 1000BaseCX Gigastack
So, I try with RME -> Tools -> Netshow. see file attached.
I get the information but I prefered to get it in with a report because I need to get thoses informations for 150 devices.
Is there a way to get it on a report ?
When I look at RME->Admin-> Inventory-> Change Filter,
I think that there are more port information compare to report generator.
Status | Parent Relative Position | Port Interface Index | Operational Status |
Manufacturer Name | Field Replaceable Unit | Alias Name | Slot Configuration |
Port Model Name | Port Vendor Type | Power Remaining | Port Serial Number |
Power Consumption(%) | Description | Power Consumption | Component Type |
Power Available | Port Index | Power Allocated | Maximum Power |
POE Admin Status | Physical Entity Name | ||
Custom report, port attribute, I can take only thoses attributes:
Maximum Power
Power Allocated
Power Available
Power Consumption
Power Consumption(%)
Power Remaining
POE Admin Status
Why there are more infiormation for change audit than inventory report ?
Thanks, Elisabeth
Inventory Change Filter : Port03-05-2010 11:55 AM
I have a bug open to make sure all of the inventory attributes seen in the Detailed Device Report are also available for custom reports (CSCsj78780). Quite a few were added in RME 4.3, but the list is still not complete.
As for Netshow, there is no way to change the output format type (i.e. you cannot make it more like the inventory reports). However, you could perhaps write a script to parse the CLI output from Netshow, and deliver a report in the desired format.
03-05-2010 01:16 PM
Do you think that there is an attribute or an snmp variable for GigaStack information like I can get with show status ?
Port Name Status Vlan Duplex Speed Type
Gi0/1 connected trunk a-full a-1000 1000BaseCX Gigastack
Gi0/2 connected trunk a-full a-1000 1000BaseCX Gigastack
03-06-2010 06:54 AM
I don't think so, but I do not have a 3750 with a Gigastack GBIC with which to test. If this data is available in RME, it would be visible in the Detailed Device Report. However, I think the type attribute will only indicate it is an ethernet port.
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide