cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
1007
Views
0
Helpful
4
Replies

Logging Issue

aneesh.ts
Level 1
Level 1

Am always receiving up logs in one of my LAN interfaces. There are n

o interface downlods.

Wondering what could be the issue. Could there be a real link flap issue.

Why could the same link always come up without going down.


001391: Jun  4 09:51:58.850 INDIA: %LINK-3-UPDOWN: Interface FastEthernet0/0, changed state to up
001392: Jun  4 12:01:19.930 INDIA: %LINK-3-UPDOWN: Interface FastEthernet0/0, changed state to up
001393: Jun  4 12:01:25.438 INDIA: %LINK-3-UPDOWN: Interface FastEthernet0/0, changed state to up
001394: Jun  4 12:02:43.599 INDIA: %LINK-3-UPDOWN: Interface FastEthernet0/0, changed state to up

Any suggestions?

Thanks in advance.

Regards,

AneesH

1 Accepted Solution

Accepted Solutions

This could be CSCsv90092.  Is CEF disabled?  If so, enabling on this interface will work around the problem.  The bug is fixed in 12.4(15)T10.

View solution in original post

4 Replies 4

Joe Clarke
Cisco Employee
Cisco Employee

What version of code is running on this device?

IOS & hardware details..

Cisco IOS Software, 1841 Software (C1841-IPBASE-M), Version 12.4(15)T9, RELEASE SOFTWARE (fc5)
Technical Support: http://www.cisco.com/techsupport
Copyright (c) 1986-2009 by Cisco Systems, Inc.
Compiled Tue 28-Apr-09 11:11 by prod_rel_team

ROM: System Bootstrap, Version 12.4(13r)T, RELEASE SOFTWARE (fc1)

NS-CHN-DLN-R01-P uptime is 16 weeks, 6 days, 4 hours, 20 minutes
System returned to ROM by power-on
System restarted at 09:57:22 TOKYO Tue Feb 9 2010
System image file is "flash:c1841-ipbase-mz.124-15.T9.bin"

Cisco 1841 (revision 7.0) with 115712K/15360K bytes of memory.
Processor board ID FHK1327736Z
2 FastEthernet interfaces
1 Serial(sync/async) interface
DRAM configuration is 64 bits wide with parity disabled.
191K bytes of NVRAM.
31360K bytes of ATA CompactFlash (Read/Write)

Configuration register is 0x2102

AneesH

This could be CSCsv90092.  Is CEF disabled?  If so, enabling on this interface will work around the problem.  The bug is fixed in 12.4(15)T10.

Hi joe,

Thank you so much mate.

You were absolutely right. We've seen a lot of throttles as mentioned in the Bug description.

Unfortunately CEF is already enabled on the router. However I again enabled it on the interface.

Not sure whether it will help.

Lemme monitor the device for a while now. Since its not impacting, nothing much to worry.

You were so helpful and I totally appreciate your effort with this.

AneesH

Review Cisco Networking for a $25 gift card