I am following the step-by-step instructions to configure mrp, and the IE4000s work like a charm as mrp clients or managers.
I tried following the same steps for IE4010s, but they don't like it. I keep getting this error:
"MRP is not supported on this interface GigabitEthernet1/26"
I have disabled profinet mrp and even profinet itself, but nothing.
Strangely, I tried to use one of the copper ports on the 4010s for the mrp (i.e. gi1/1), and mrp client on the 4010 works fine. It is only if I try using one of the SFPs that the switch does not like it.
I am using the same SFP model for the IE4000s, and they work just fine. Do I need to configure something special for the SFP ports for MRP to work on the IE4010s?
PRTG system in place running other sensors on the same host, which are working. Ive added syslog receiver sensor and receiving PRTG data from switch that increases drops, errors and warning stats that disappear after a few minutes. Within mess...
Hi, here is an example how to configure IP-NAT, GRE, IPSEC. I've seen plenty of questions and this might be a good solution! (Mostly the use of commands that might remind u) IP NAT======================================================================...
Hi everyone.I have a problem in my Network.So i have 3 routers and a firewall in my topology. I have configured OSPF and all routers works expect R3 (see in the image below)When I watch my neignbor in R3 it says :192.168.7.7 1 INIT/DROTHER 00:00:37 10.0.2...
Host Onboarding is the term used when connecting an endpoint (hosts , IOT , Other devices) to the fabric , and can be accomplished in a couple of ways.One option is the "static" approach as oppose to the dynamic and secure approach using&nbs...