Netflow don't show output information

[wpereira]

Hi there,

I have applied the configuration below but my Netflow analyzer just show the input information.

http://www.cisco.com/c/en/us/products/collateral/switches/catalyst-2960-x-series-switches/solution_overview_c22-728776.html

Is there anything to do in order to show output information?

Please let me know.

Thanks in advance. 

[jonathanlunt]

ip flow ingress/ip flow egress should be the commands you need. (if your using version 9)

you can confirm with a show ip flow interface (I think)

[Michael Patterson]

Compare your configuration to the 4 steps listed here: https://www.plixer.com/blog/netflow-lite-2/cisco-2960-x-netflow-lite-configuration/

Pay close attention to step one when you setup the record.  I hope this helps.

Mike