Hi All,
I have an issue with netflow coming from a Nexus 5k at one of our client's site's.
The 5k is setup to send netflow to a Cisco Prime server sitting on site. Cisco Prime sees the device as a data source, but no flows are shown in the data sources table. Although this is an issue, our main issue is that when I try and look at the interfaces in Cisco Prime, the two sub interfaces I configured to capture flows don't show up in Cisco Prime as interfaces. They aren't even in the interface groups.
Here is some background on the netflow config
GEPF-HAM-NX5K-SW1# show flow exporter
Flow exporter HSRP_HUAWEI_NETFLOW:
Destination: 172.x.x.x
VRF: xxxx (1)
Destination UDP Port 9991
Source Interface Vlan160 (172.x.x.x)
Export Version 9
Exporter Statistics
Number of Flow Records Exported 44099
Number of Templates Exported 1392
Number of Export Packets Sent 18080
Number of Export Bytes Sent 2821724
Number of Destination Unreachable Events 0
Number of No Buffer Events 0
Number of Packets Dropped (No Route to Host) 0
Number of Packets Dropped (other) 0
Number of Packets Dropped (LC to RP Error) 0
Number of Packets Dropped (Output Drops) 0
Time statistics were last cleared: Never
flow exporter HSRP_HUAWEI_NETFLOW
destination 172.x.x.x use-vrf xxx
transport udp 9991
source Vlan160
version 9
flow record HSRP_HUAWEI_NETFLOW
match ipv4 source address
match ipv4 destination address
match ip protocol
match ip tos
match transport source-port
match transport destination-port
collect counter bytes long
collect counter packets long
collect timestamp sys-uptime first
collect timestamp sys-uptime last
collect ip version
sampler PRIME
mode 1 out-of 65536
flow monitor HSRP_HUAWEI_NETFLOW
record netflow ipv4 original-output
exporter HSRP_HUAWEI_NETFLOW
Please let me know if you have any idea what would help out here.
