cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
583
Views
0
Helpful
5
Replies

NME-AIR-WLC config fetch fails RME 4.2

chharris41
Level 1
Level 1

I am having problems with the config fetch on the NME-AIR-WLC8-K9 running 5.1.151.0. I am using telnet, not ssh so the bug documented for other wlc's doesn't apply. I've checked/re-checked credentials, I can telnet fine to the device but config fetch fails (however inventory collection does work). I have installed all of the relevant device updates.

Please let me know if you have any ideas on this.

Thanks

5 Replies 5

Joe Clarke
Cisco Employee
Cisco Employee

Enable ArchiveMgmt Service debugging under RME > Admin > System Preferences > Application Loglevel Settings, repeat the job, and post the dcmaservice.log.

Ok - log file is attached.

This device does not appear to be supported for configuration yet. What is its sysObjectID?

OID:1.3.6.1.4.1.9.1.818

Yes, this particular WLC is not yet supported in RME 4.2. There is currently no ETA on when support will be available.

Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community:

Innovations in Cisco Full Stack Observability - A new webinar from Cisco