Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I recently did a new install of LMS 4.0 in a VM - running Win2008 R2 on ESXi 4.1 (used the R2 patch from CCO to do install). Server has dual quad-core processors, 16GB RAM dedicated to the VM - well over on all the min requirements. I have the follo...
I just installed QPM 4.1 on an LMS 3.1 system. The install went fine with no errors, etc..I imported all DCR devices into QPM with no problems and imported some existing QOS policies. I am however unable to view either of the real time charts (unde...
I am having problems with the config fetch on the NME-AIR-WLC8-K9 running 5.1.151.0. I am using telnet, not ssh so the bug documented for other wlc's doesn't apply. I've checked/re-checked credentials, I can telnet fine to the device but config fetch...
I installed the latest MDF that includes support for the ACE 4710, it is "seen" by CS and RME, however I am unable to get RME to fetch the config. I have checked the credentials and SNMP strings several times. I did a packet capture and it appears ...
During past couple months we have been experiencing seemingly random cases of losing EIGRP neighbor relationships from our many remote sites to the provider edge. All sites are on MPLS and neighbor with a PE router. When this happens it causes majo...
Joe,THe VM is configured with 4 vCPU's, the host machine has 2 x quad core processors, so I figured half of that goes to LMS. Should I decrease the amount of vCPU's? Currently there are no other VM's on this host machine, at most we'd put one other...
Maybe memory leak isn't the best description, but considering that Cisco's recommended spec for total memory is 8GB I'd say either the app is using memory very inefficiently or they need to bump up the spec. Fortunatley I knew from experience and al...
I am having problems with the config fetch on the NME-AIR-WLC8-K9 running 5.1.151.0. I am using telnet, not ssh so the bug you mentioned doesn't apply. I've checked/re-checked credentials, I can telnet fine to the device but config fetch fails (how...
