Out-of-Sync Summary RME 4.0

[rjphelps]

When I run the Out-of-Sync Summary report, I get quite a few entries that when I click the diff icon I get a message that says no differences found. The only thing I can think of is that when populating the Out-of-Sync Summary report it doesn't take into account the Excluded commands, but when running a diff report it does.

Any thoughts?

[getwithrob]

What I do to correct these devices in RME 3.5 (LMS 2.2) is compare the startup and running configs by going to RME > Config Mgmt > Compare configs > Startup vs. Running. This gets the devices out the Out of Sync reports. I've also found that a number of commands that are dynamic in nature like ntp, username, etc have to be added to the CommandsExcludes*.ini files in the /opt/CSCOpx/objects/cmf/data (I think that's where these CommandsExclude*.ini files live.

[rjphelps]

In RME 4.0 The Exclude commands can now be entered from the GUI instead of the file. The problem to your work around is the list in the Out-of_sync report has about a 100 devices in it. I did try your method on a handful but they remain in the out-of-sync report. These configs have the ntp commands but they are in the Exclude list.

[getwithrob]

You got me....

I haven't done anything with LMS 2.5.

All I can say is "good luck"!!!