04-23-2009 11:50 PM
Hi,
We have LMS 2.6 with RME 4.0.5. For few devices we are getting partially successful in CONFIG ARCHIVE. In the log i found PRIMARY START-UP, RUNNING are failed but VLAN RUNNING was successful.
The error message is below,
1. 10.108.33.10 PRIMARY STARTUP Apr 24 2009 13:10:17 Failed to get the start tag-! in the configuration.Check if the startup-config file is present on the device. PRIMARY-STARTUP config Fetch Operation failed for TFTP. Failed to detect SSH version running on the device. Failed to fetch config using RCP.Connection refused: connect Verify RCP is enabled or not.
2. 10.108.33.10 PRIMARY RUNNING Apr 24 2009 13:10:35 Failed to get the start tag-! in the configuration.Check if the startup-config file is present on the device. PRIMARY-RUNNING config Fetch Operation failed for TFTP. Failed to detect SSH version running on the device. Failed to fetch config using RCP.Connection refused: connect Verify RCP is enabled or not.
3. 10.108.33.10 VLAN RUNNING Apr 24 2009 13:10:42 Successful
Pls help us to resolve this issue.
Thanks in advance.
Regards,
Pradeep
04-24-2009 09:13 AM
This is most likely caused by command authorization. Make sure the user configured in DCR has access to run "show running" and "show startup".
04-26-2009 11:18 PM
Hi Jclarke,
Thanks for your response. But the user i configured in DCR has the privilege for show running and show start. I manually logged in the switch with the same username and password and the show runn and start commands are working.
04-27-2009 09:18 AM
Then you should start a sniffer trace filtering on telnet traffic to this device. Perform a new Sync Archive to this device, then look at the sniffer trace when it fails. That should illustrate the problem.
04-28-2009 05:23 AM
I will do the sniffer trace and let you know.
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide