cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
1090
Views
0
Helpful
1
Replies
HotDol
Beginner

please help... how should i config alteon L4 switch

FWLB L4 Switch Active-Standby Mode

지현캡처.JPG

i built fwlb with 2 alteon l4 switchs(using LVS) and 2 ips(snort). (routing protocol is OSPF)

but... if two ips is  jammed, endpoint devices can't use internet.

 i wanted spare router for last resort.

so.. i built new router(on the far right) and routed ospf

suddenly.... problem happend !!       all packet passed by the new router!!even if icmp health check!! (it wasn't my intension)  

i need that  the packets pass by two ips(with fwlb) and if ips die, new router activate itself.  

how should i config the two l4 switchs?

 

1 REPLY 1
marce1000
VIP Advisor

Content for Community-Ad