Possible to change displayed columns of RME Report Generator

[axa-wongjeff]

I created a Software Report from the RME Report Generator. The CSV file has the following default colums in the report:

Device Name

Updated At

System Description

Location

Contact

Serial Number

Vendor Type

SW Version

Management Type

Config Register Value

I would like to add a column called "IP Address" which would be the IP address of the device. This is so that whomever looks at the report has both the name and IP address of the device.

Is there a file I can edit to have RME add the attribute/credential to the report?

Thanks.

[Joe Clarke]

No, the built-in reports are fixed, and cannot be changed.  However, you could create an inventory custom report with the following ruleset, and get close to what you want.

System:Name:equals:All
AND:IP Address:IP Address:equals:All
AND:System:Description:equals:All
AND:System:Location:equals:All
AND:System:Contact:equals:All
AND:Chassis:Chassis Serial Number:equals:All
AND:Chassis:Chassis Vendor Type:equals:All
AND:Processor:SW Version:equals:All
AND:Processor:Config Register Value:=:All