02-20-2014 03:25 PM
Recently installed PI2.0. Following collection and archive only the IOS devices show vlan and IP interfaces from the device work center. The Nexus 7k & 5k gear do not. Is this expected behavior for Nexus OS in Prime or is something mis-configured ?
Thanks in advance for your suggestions !
Solved! Go to Solution.
02-20-2014 05:09 PM
Hi ,
I have checked and confirmed that Unfortunately this feature is not supported for NEXUS . I mean the VLAN and Interface information.
and I think "port-channels" are also not supported.
But this is in the road map ,soon we will have this feature supported as per my knowledge.
Thanks-
Afroz
[Do rate the useful post]
****Ratings Encourages Contributors ****
02-21-2014 04:40 AM
"Cisco Prime Data Center Network Manager" ideally yes... but I am not an expert on that
Thanks-
Afroz
02-20-2014 05:09 PM
Hi ,
I have checked and confirmed that Unfortunately this feature is not supported for NEXUS . I mean the VLAN and Interface information.
and I think "port-channels" are also not supported.
But this is in the road map ,soon we will have this feature supported as per my knowledge.
Thanks-
Afroz
[Do rate the useful post]
****Ratings Encourages Contributors ****
02-21-2014 04:36 AM
Holy Moley - I suspect then the Prime DCNM arm does, do you know ?
02-21-2014 04:40 AM
"Cisco Prime Data Center Network Manager" ideally yes... but I am not an expert on that
Thanks-
Afroz
02-21-2014 06:18 AM
Thanks Afroz - do appreciate your thoughts !
How does one rate these - I see the start bar doesn't allow me to change it ?
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide