cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
568
Views
0
Helpful
1
Replies

Prime Infra 2.0 alert when syslog message received

Russ Kwong
Level 1
Level 1

Dear member,

May I know did prime infra 1.3, 2.0 can support alerted user when received a syslog message?

if yes, and configiuration guide for reference?

Regards

1 Reply 1

AFROJ AHMAD
Cisco Employee
Cisco Employee

Hi Russ,

PI does not actually keep a record of the raw syslog  messages it receives, and there is no report for syslogs. When PI receives a syslog, it will immediately process the message and convert it to an event/alarm.

Also, note that PI only processes severity 1 and 2 syslogs. The closest thing you can get to a  syslog report

would be to run anadvanced search for events

For other alarms and events you can go to Operate > Alarms
& Events > Email Notification page. Make sure that the alarm categories that you
want to have notifications for also has the Enable checkbox checked.

Thanks-

Afroz

[Do rate the useful post]

Thanks- Afroz [Do rate the useful post] ****Ratings Encourages Contributors ****
Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community:

Innovations in Cisco Full Stack Observability - A new webinar from Cisco