02-27-2015 08:10 AM
Hi,
I'm struggling with the cisco prime infrastructure 2.1 again :]
When i create a configuration task (it could be anything like an access list etc.) and deploy that to a switch or group of switches it does not work.
In the Job Dashboards i just see that the job has failed, and there is no details on what would be the reason, just "No data available".
This was working before, and all snmp/cli credentials are up to date, and all devices are sync.
Any suggestion on what could that be ?
Pawel
02-27-2015 11:48 PM
Hi,
Please create a simple CLI template e.g "snmp-sever community ASHOK RW" as per below navigation:-
Design > Configuration > Feature Design > Templates > CLI Templates > CLI > Save as a New Template
Now, Deploy the same as per below navigation
Configuration Deployment > Configuration Tasks > Templates > My Templates
if still job fails, we need to collect the debug logs
- Ashok
***************************************************************************************************************
Please rate the post or mark as correct answer as it will help others looking for similar information
**************************************************************************************************************
03-02-2015 03:32 AM
Hi Ashok,
This fails with the "No data available" error as every other job;
Where can i configure and collect the debug logs ?
Pawel
03-04-2015 02:34 AM
Great support for the great cisco software -
cisco really sucks at developing management software :[
PK
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide