There is no trace of EEM on my router. I have an 861 running universal 15.0(1)M4 with an advsecurity licensce. This is what I get under global config:lch-nj_mana(config)#e?enable end energywise eouerrdisable exception exit Am I going c...
I am attempting to add my ASAs into prime but get stuck almost instantly after adding the new device. Prime is able to get the device name and Device type (Cisco ASA-5580 Adaptive Security Appliance Security Context) Admin status shows up as Managed ...
Hi All,Recently we have witnessed getting false alarms - operationallydown from Dfm from multiple routers and switches during early morning.When we checked the router switches, there were no events or logs related to this. Then we confirmed that thes...
Hello everyone.I want to improve the network of the University where I work, which attached the Images of the current state and desired.We have two circuits one for classroom Internet, wifi, laboratories (30 MB) and one for administrative staff (12 M...
Hi all,I have created an EEM script for my switch to perform a few commands I would normally use then email that output to my mail address. The event triggers on interface down and emails ok, but it's missing one of the commands (it only shows the ou...
I have a Cisco Prime Infrastructure version 1.3 virtual appliance and we have a new Prime Infrastructure version 2.1 virtual appliance set up. I would like to get the wireless information put into the new server. This includes the WLC and APs and the...
Hi , I have cisco 3945 Router and IOS version c3900-universalk9-mz.SPA.152-4.M4.bin"this router is a VXML gateway configured for UCCE setup. My requirement is,whenever the VXML gateway not able to reach CVP it plays survivability.tcl script and log t...
Hello Community,can someone please provide a step-by-step guide (or at least the VSA part) for RADIUS configuration on a Windows 2008 R2 server for Prime Infrastructure 2.1 please?We already tried several setups with guides for PI 1.4 without success...
Hi,Need some help please :-)I need to use CDP to glean the particular model of a Cisco IP phone attached to a switch. I know we can use the $_nd_cdp_capabilities_string but cannot figure out how to use this for the phone model.Show cdp neighbors deta...
Is it OK to proceed this update in one step? From 12.2(25)SEE3 to the current release, 12.2(55)?Are there any steps necessary in between like do an upgrade to an earlier version before?Thank you for your advice.fuz
Hi Guys, I have a 2801 router that i want to install a HWIC-1GE-SFP into and it is currently running IOS ver. 12.4(21a) spservicesk9 and i would like to know how to determine if a IOS revision is compatible. I have read this article to gain info rega...
Hi team Is there any way to monitor the number of sessions established to particular url or website from an application level. No access to firewall and router. Any software or script which helps to get all those required date of web monitoring. Plea...
Hi.My Switches are c2950/60 and sg300 series.I configured them using ntp. They all have status "synchronized" when I do <show sntp status>.switch#show sntp status Clock is synchronized, stratum 3, reference is 82.197.188.130, unicastUnicast servers:S...
Please see attached image. I would like to know where in LMS 4.2 you can edit/configure the syslog analyzer to display a different description/explanation and recommended action for various syslog messages. We're starting to roll out 802.1x on our ne...
