Prime Infrastructure 2.2 No displaying client data using SNMP v3

[richardpreece]

When using Prime 2.2 with SNMP

Using SNMP version 2 we get the client data displayed under Device Details-Clients-Current associated Wired Clients as above.

However, nothing is displayed if we use SNMP v3 with full MiB access.

Any ideas as to why this doesn't work with SNMP v3?

Thanks

Richard

[Marvin Rhoads · Accepted solution]

I recall a couple of threads that reported similar issues. Please have a look at them (below) and see if either helps.

Root cause is snmp-server engineID duplicated:

https://supportforums.cisco.com/discussion/13122461/prime-infrastructure-31-snmpv3-issues

Root cause is SNMP contexts must be defined:

https://supportforums.cisco.com/discussion/11841726/endhost-unreachable#3960325

[Pari Thiagasundaram]

I suggest that you upgrade the PI code to the latest one as well. 

[richardpreece]

Hi Pari,

we would but the h/w isn't compatible with the next version.

[richardpreece]

Hi Marvin,

It was the context I required. I just missed out the MiB viw required at the end initially. The following now works!

snmp-server group RO v3 auth context vlan-id read FULL-MIB-ACCESS  

Many Thanks

Richard

[Marvin Rhoads]

Great - thanks for reporting the successful outcome and rating.