Prime Infrastructure and syslog

[sdavids5670]

In the "Cisco Prime Infrastructure 2.0 User Guide" it states:

Prime Infrastructure logs all emergency, alert, and critical messages generated by all devices that are

managed by Prime Infrastructure.

Prime Infrastructure also logs all SNMP messages and syslogs it receives. To view syslogs, choose

Operate > Alarms & Events, then click the Syslogs tab.

Syslog Pre-defined Filters

Prime Infrastructure uses the following syslog filters:

• Severity 0 and 1

• Severity 2

• Environmental Monitor

• Memory Allocation Failure

• Catalyst Integrated Security Features

• Cisco IOS Firewall Denial of Service

Can this be changed or is this Pre-defined filter something I have to live with?  If it can be changed, where?  The user guide doesn't get into it (at least not that I could find).

Thanks

[AFROJ AHMAD · Accepted solution]

Hi ,

Directly only sev 0,1 and 2 syslogs are supported in PI 2.x  so far.

but you can edit a properties file and get it working for other severity as well.

check the below link:

https://supportforums.cisco.com/discussion/11645481/prime-infrastructure-12-syslog

hope it will answer your query.

Thanks-

Afroz

****Ratings Encourages Contributors ****

[sdavids5670]

Thanks!