10-20-2016 01:53 AM
Hello everybody,
I've just updated my Cisco 3845 from 12.4 to the IOS 15.1(4)M4. I have a Centreon with a script perl who check the ospf neighbor status and an Observium which polling with MIB OSPF. Since i've updated my router, when i check the SNMP OID OSPF, it returns just one OSPF Router (i have 18 process OSPF and SNMP show me the last OSPF Process 18 not the 17 before). My Observium show me the last OSPF too.
How i can check all my OSPF Table instead of one OSPF ? Before the update all my supervision works properly !
Thanks in advance.
Best Regards
Solved! Go to Solution.
10-24-2016 06:40 AM
Hi.
I am not an expert on OSPF but after searching a bit, I found several similar symptoms on other customers that upgraded to 15.1 and could no longer poll the whole OSPF table.
According to the info I found below, the pre-15.1 behavior should not have been permitted and the behavior seen now is the correct one, which should limit the access to routing contexts.
http://www.cisco.com/c/en/us/support/docs/ip/simple-network-management-protocol-snmp/111869-ospf-with-snmp.html
Hope this helps,
Luis
10-24-2016 06:40 AM
Hi.
I am not an expert on OSPF but after searching a bit, I found several similar symptoms on other customers that upgraded to 15.1 and could no longer poll the whole OSPF table.
According to the info I found below, the pre-15.1 behavior should not have been permitted and the behavior seen now is the correct one, which should limit the access to routing contexts.
http://www.cisco.com/c/en/us/support/docs/ip/simple-network-management-protocol-snmp/111869-ospf-with-snmp.html
Hope this helps,
Luis
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide