cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
1034
Views
5
Helpful
4
Replies

Purge archive Mgmt Problem

angelapreta
Level 1
Level 1

On CW 2.5 I have configured the purge of archive Mgmt. It does not work. After 15h the job finished with fail status. I have incresed the archive Mgmt fetch settings suggestet in the error status from the each device. Can someone help.

4 Replies 4

Joe Clarke
Cisco Employee
Cisco Employee

Exactly which version of RME do you have? Exactly what is failing? Is it the config purge job, or is it a configuration sync job (i.e. a job that is fetching the configurations from your devices)?

RME version: 4.0.4

it is the config purge job

The job does not purge any conf-files. The policy does retain 5 versions

For this, you should enable ArchiveMgmt Service debugging under RME > Admin > System Preferences > Loglevel Settings. Then wait for another job to run, and look for errors in dcmaservice.log. Note: configurations with associated ChangeAudit records will not be purged, so make sure you are purging those as well.

debugging for ArchiveMgmt Service is active

I found no information or errors in dcmaservice.log for this purge job. I changed the purge policy with same result -> Failed.

There is a ChangeAudit job running

Thanks

Review Cisco Networking for a $25 gift card