12-07-2018 12:24 AM
Good afternoon.
Can someone explain to me the point about the status of SNMP traps.
We use WhatsUP Gold NMS, and NMS that are not shown, some interfaces of the device being added.
On the device itself, when checking SNMP traps, we observe the following situation.
SU-AS5350XM-ATK6#show controllers E1 | i up
E1 3/0 is up.
E1 3/1 is up.
E1 3/2 is up.
E1 3/3 is up.
E1 3/4 is up.
E1 3/5 is up.
E1 3/6 is up.
SU-AS5350XM-ATK6#show snmp mib ifmib ifindex det
Description ifIndex Active Persistent
----------------------------------------------------------------
GigabitEthernet0/0 2 yes enabled
Loopback0 19 yes enabled
Null0 7 yes enabled
Serial0/0 4 yes enabled
VoIP-Null0 6 yes enabled
GigabitEthernet0/1 3 yes enabled
Serial0/1 5 yes enabled
Serial3/0 1 yes enabled
Serial3/0:0 16 no enabled
Serial3/2:0 20 no enabled
E1 3/0 8 no enabled
E1 3/1 9 no enabled
Serial3/4:0 17 no enabled
E1 3/2 10 no enabled
Serial3/6:0 18 no enabled
E1 3/3 11 no enabled
E1 3/4 12 no enabled
E1 3/5 13 no enabled
E1 3/6 14 no enabled
E1 3/7 15 yes enabled
Why is the interface is UP but status ACTIVE is NO???
12-07-2018 02:09 AM
- I am not sure SNMP TRAPS are related to you questions; traps are informational messages send to a trap receiver upon certain conditions. In your case, the not active might indicate that there's currently no traffic on the designated port.
M.
12-07-2018 01:07 PM
According to the description of the team from the site Cisco
https://www.cisco.com/c/en/us/td/docs/ios-xml/ios/snmp/command/nm-snmp-cr-book/nm-snmp-cr-s1.html#wp6564388800 - YES means that interface is active.
From my output interface E1 3/7 is DOWN but status is ACTIVE.
Interface(controller) E1 3/6 is UP and worked but status in NOT ACTIVE. How can i activate this interface?
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide