Resolved! How to monitor FAN on Switch 2960 ?
Hi ! I don't find the answer on the internet, so, I ask it here.Can we monitor fans on the cisco 2960 ?If we can, which OID we should use ? By advance, thank's for answers.
Forum Posts
I have a Ubuntu machine which acts as a TFTP Server. I want to configure my cisco ios routers to take configuration from this TFTP server at boot time.I have a few doubts- Where do I store the configuration file for my cisco router in the TFTP Server...
Hi guys, im having troubles with my network.This is the scenario, two ASAs 5520 connected with MPLS, behing those ASAs a Cisco 3750 switch, and behind those switches a SF300 switch.The problem is the next one:Two computer connected to the same VLAN o...
A few months back I pushed out a configuration for our new AAA servers. As part of that push I tried to also delete the old AAA servers. This however did not work on all devices so now I have to create a policy that will find the old AAA servers bo...
i need to have two cisco switches which would be equivalent to my existing setup for backup purpose currently i have in my setup avaya ERS 2526t and 4526t switches and SR 1001S nortel router. i need to have cisco devices which would be compatible wit...
Hi all, currently am evaluating Prime 3.5. One Use Case is to power cycle a flapping AP with PoE. Ist there a fast way to do it? thanks in advance,ben
i having two doubts in CEF 1) usually we can't debug the packets which is not processed switched by cpu,,FIB table is in hardware, but after putting (no ip route cache cef) in interfaces i can see debug the packets which showing as routed from FIB ,...
I am scanning the documentation for CPI 1.2, trying to get it to use CSACS 5.3 for my authentication/Authorization. The docs say to create a TACACS Shell Profile, and add the TACACS A/V Pairs as needed... um... nowhere could I find a listing of AV Pa...
Resolved! CCIE LAB server Recommendation
HI, i want to but a server for my CCIE preparation .so which server i should buy for my ccie LAB preparation . Please recommend me for my CCIE preparation . Thanks
Resolved! Blocking sites using Class-Map
I used the Class-map command to block some websites but it did not work, this is commands i used. #class-map match-any blocksitesclass #match protocol http host *youtube* #match protocol http host *porn* #exit #do show class-map #policy-map blocksite...
Hello Everyone, I've one old Cisco 1841 Router running as Edge WAN Router. Now, I want to forward ports through it just like any normal home routers.... Kindly help. Pasting Show run.... EdgeRouter#show runBuilding configuration... Current conf...
Hi Cisco Community We are working on a solution involving the deployment of Firepower 7125 hardware sensors (i.e. Cisco part number FP7125-K9) managed by Firepower Management Center 4000 appliances (i.e. Cisco part number FS4000-K9) and plan to deplo...
Is Stateful-NAT embedded with HSRP? Is there no way that Stateful-NAT can be implemented stand-alone or with IP-SLA?
Hello, When you have two interfaces configured on the PI-UCS-APL-K9, which interface is referenced when the Prime discovery process modifies "the device configuration(s) to add a trap receiver in order for Prime Infrastructure to receive the necessar...
We have our devices configured to save the config on a tftp server, with these commands: switchTest#show runarchivepath tftp://10.216.141.156/switchTest-write-memory I want to change this configuration, because our colleagues from server departament ...
