I am trying to get issue CLI commands to running-config using the "snmpset" command. The command below appears to take just fine, but the commands are not reflected in the running-config. The SNMP RW string I'm using has vdc-admin rights, so I'm not sure why the commands do not take. The command uses a config file (9.0.46.30) on the server I'm accessing the device with. I don't think it's the command so much as there seems to be an issue with the device setup itself. It's a Nexus sub-vdc.
Any help is greatly appreciated. I'm pulling my hair out.
snmpset -v2c -c ATT-DIMERW 9.0.46.30 .1.3.6.1.4.1.9.9.96.1.1.1.1.2.3194 i 1 .1.3.6.1.4.1.9.9.96.1.1.1.1.3.3194 i 1 .1.3.6.1.4.1.9.9.96.1.1.1.1.4.3194 i 4 .1.3.6.1.4.1.9.9.96.1.1.1.1.5.3194 a 135.89.52.249 .1.3.6.1.4.1.9.9.96.1.1.1.1.6.3194 s 9.0.46.30 .1.3.6.1.4.1.9.9.96.1.1.1.1.14.3194 i 4
