Network Management

Hello Team, Thank you for your ususal support. Trust my mail meets you well. I kindly need a technical assistance for generating a CSV file or XML file template  that would be used for  bulk import of network devices on CISCO PRIME LMS 4.2. I tried u...

Hello I am using a RV180W router and had setup  a web server in LAN. I used DMZ to expose the web server so IP from outside could access my web server. This used to work fine.  However, recently, I found outside IP could not visit my web server and a...

Hello,I've written two applets (see below). The first is triggered when a BGP route is removed from the table. The action is to send an email to the helpdesk. the second applet sends a second email when a route has been added to the BGP table (the as...

Dear! In my custome they have switches 3560x and 3750x and this model don´t support NetFlow, unless if they havey a special module, but in this custome they don´t have. How can I discovery witch applications is consuming more link?Such as:SAP is cuns...

Hello, TeamNow our account se is testing EEM script for IOS-XR System.Main point of script is monitoring interface CRC error incremental then display syslog message with CRC values. This is our script header::cisco::eem::event_register_snmp oid 1.3.6...

hello everyone, i'm a student and I have to do a final presentation to recommend a protocol to be implemented into a company, I worked at the company as an intern in their telecommunications department and my project has been given by them. the proje...

I've been unable to get netflow working on a Cisco 3750x with a C3KX-SM-10G module.  I went over the configurations with Cisco TAC and we verified they are correct.  However, Cisco states that I have to use the tenGigabitEthernet interfaces.  Problem...

When trying to add new CMI vlans for their virtual workstation and server, I am getting the attached WARNING. Sounds like their is an issue with CIMC version in the following Chassis: i have a total of 18  blades; 16 are loaded with ESXi 5.1; these w...

Hello   I have set snmp on my cisco cat3750 and cat2960: snmp-server community public RO.   I have cheked it by snmpwalk -c public -v 1  <ip of my switch> system. It works!   But when I try to get  mac address table through snmwalk -c public -v 1 <ip...

I am having an issue were my 4948 switches are not sending the vlan index OID 1.3.6.1.2.1.17.7.1.4.2.1.2. Has anyone run into this and if so how can I fix it?