Ok serveral things to look at:
on the switches you should have something near this in the configuration (this is from 7-6-9.bin)
set logging console enable
set logging telnet enable
set logging server enable
set logging server (ip address of your ciscoworks box)
set logging level cdp 4 default
set logging level mcast 4 default
set logging level dtp 4 default
set logging level dvlan 4 default
set logging level earl 4 default
set logging level ip 4 default
set logging level pruning 4 default
set logging level snmp 4 default
set logging level spantree 4 default
set logging level sys 4 default
set logging level tac 4 default
set logging level tcp 4 default
set logging level telnet 4 default
set logging level tftp 4 default
set logging level vtp 4 default
set logging level vmps 4 default
set logging level kernel 4 default
set logging level filesys 4 default
set logging level mgmt 4 default
set logging level mls 4 default
set logging level protfilt 4 default
set logging level security 4 default
set logging level radius 4 default
set logging level udld 4 default
set logging level gvrp 4 default
set logging level cops 4 default
set logging level qos 4 default
set logging level acl 4 default
set logging level rsvp 4 default
set logging level ld 4 default
set logging level privatevlan 4 default
set logging level ethc 5 default
set logging level gl2pt 4 default
set logging server facility LOCAL7
set logging server severity 6
set logging timestamp enable
set logging buffer 500
On your ciscoworks server:
1. Are both of your devices in the inventory ?
2. When you run an "unexpected device" report in RME does an ip address associated with either of those devices show up ?
