Telnet to the switch doesn't display user prompt

[Bert9]

I have an issue with remote access to one of our c3560 devices.

VTY lines are configured to use Telnet and and aaa model for authentication. Once i try to connect to the device after few seconds it displays %Authentication Failed, without even displaying user prompt.

Config looks something like this:

aaa authentication login vty group tacacs+ line

line vty 0 4
exec-timeout 60 0
logging synchronous
login authentication vty
length 0
transport input telnet
line vty 5 15
exec-timeout 60 0
login authentication vty
transport input telnet

[Bert9]

I've mentioned above that this software does not give me an option to configure Tacacs per vrf.

Neither of the commands below are available:

ip vrf forwarding (in aaa group server)

nor

tserver-tacacs host ip vrf

[jiji31]

you will using login         local account. as kumar suggest to you.  https://audacity.onl/ https://findmyiphone.onl/ https://origin.onl/

[kushalkhanal]

Hi,

Too late to the party but if you are connected but not getting prompt, please check the vty speed. If you are consoling to a Cisco router , you need to change your vty port speed to 115200. This can be one of the reason.

Thanks

Kushal