Unable to add VLAN from CNA

[steffenscheen]

Hello. We hare 2x Cisco 2960X 48 TS-L Stacked, IOS v 152-3.E

CNA Version is 6.1.

I can not add New VLANs fron CNA.

When i create a VLAN, apply and refresh, its gone.

I can add VLAN from CLI without problem.

is this a known problem?

[dale.magnant]

Hello,

I have experienced the same problem using CNA v6.2 and now with v6.3 using Cisco C2960X series switches, specifically (WS-C2960X-24TS-L, and WS-C2960X-8PC-L).  As the original poster above noted, CNA will allow you to add the VLAN, hit Apply, and walk away thinking the VLAN has been added.  However if you immediately go back to verify, the newly 'added' VLAN will not be present.  As noted above, if the VLAN is added via the CLA, it will then be visible when checked within CNA. 

Other switch series such as the base 2960 and 2960S series to not seem to exhibit this problem.

I posted a description of this problem back in March at the link below, but received no response.

It would be nice to hear from Cisco on this issue as this significantly undermines the usefulness of CNA.

https://supportforums.cisco.com/discussion/12928766/cisco-network-assistant-v62-problem-creating-vlans

Thank You

Dale Magnant