11-03-2011 07:36 AM
Hi,
I can't choose any devices when I try to launch a NetConfig Job in LMS 3.2.
I have to check in the job summary if the device on which I'll apply the job is the good one.
Unfortunately, this problem doesn't appear every time so I don't know where to look for an answer.
Regards,
11-03-2011 10:07 AM
Hi ,
Just make sure RMEOGSServer is running , using pdshow command,
If yes, then I would request you to Update the device pacakges for RME.
Thanks
Afroj
11-04-2011 01:52 AM
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide