el 01-13-2014 12:48 PM
LMS 3.2 - RME 4.3.1
I'm having issues using NetConfig to push a new login banner. I believe the issue is because the router or switch returns a line after the command banner login ^ - the router or switch will return a line stating "Enter TEXT message. End with the character '^'"
Here is an example;
Router(config)#banner login ^
Enter TEXT message. End with the character '^'
I've tried an Adhoc Netconfig job similar to the following;
banner login ^
This is an example of our new banner.
bla, bla, bla,
bla, bla, bla
This is the end of our new banner.
^
I've also tried using the pre-defined NetConfig task called Banner.
In both instances, the jobs failed due to the following;
"Command(s) failed on the device Insufficient no. of interactive responses(or timeout) for command: banner login ^."
Is there a way to enter a <wait> or something in the adhoc job?
Or, do you know of a way to use NetConfig to push new Banners?
Thanks,
Mike S.
¡Resuelto! Ir a solución.
el 01-13-2014 05:09 PM
Hi Mike,
For multi-line banner command, you *should* useand --Now Run the Banner like below example:banner login ^C************************************** !!!!! ADVERTENCIA !!!!! this is the Banner
you will love it
hope it will work for you
******************************************************^C
Thanks-
Afroz
[Do rate the useful post]
el 01-13-2014 05:09 PM
Hi Mike,
For multi-line banner command, you *should* useand --Now Run the Banner like below example:banner login ^C************************************** !!!!! ADVERTENCIA !!!!! this is the Banner
you will love it
hope it will work for you
******************************************************^C
Thanks-
Afroz
[Do rate the useful post]
el 01-15-2014 07:23 AM
I created a new Adhoc Netconfig job in the following format.
banner login ^
This is my test banner.
Testing, testing, testing.
^
The odd thing is, the job failed, yet the switch did accept the banner command. The new login banner was there when I connected to it.
Here is the Failed error message;
Command(s) failed on the device Insufficient no. of interactive responses(or timeout) for command: banner login ^
I'd obviously like to know why the job said it failed, yet the command did succeed.
Thanks,
Mike S.
el 01-15-2014 07:27 AM
there were few known issue in LMS 3.2 so that could be one of the reason.
I would suggest to upgarde the LMS to LMS 3.2.1
hope my post helped you !!!
Thanks-
Afroz
[Do rate the post]
*** Rating Encourage Contributors *****
el 01-15-2014 08:14 AM
Your post helped a lot. Thanks!
el 01-16-2014 12:24 PM
I figured out why the Netconfig jobs were failing. It was because one of the lines on our new banner was too long (not sure what the character limitation is exactly). I inserted a line break in that sentence and the jobs worked.
I also ended up using the pre-defined Netconfig Task for Banner. It eliminated the need to use the multi-line command you mentioned above.
I just wanted to let you know the end result.
Thanks again for the help,
Mike S.
el 01-16-2014 07:54 PM
Thanks for updating us.. this will help other too
Descubra y salve sus notas favoritas. Vuelva a encontrar las respuestas de los expertos, guías paso a paso, temas recientes y mucho más.
¿Es nuevo por aquí? Empiece con estos tips. Cómo usar la comunidad Guía para nuevos miembros