Hello,We have LMS 3.2 installed and the backup is failing with the following message"Cannot create or back up tar file. Backup cancelled. Verify that you have write-access to this directory."I have removed Cygwin and also the set the backup to offlin...
I just received a new 2960-X switch running sw release 15.0 and want to add it as a member to an existing stack of 2960-S switches. The 2960-S switches are running sw release 12.2.58.SE2. I'm thinking the 2960-X isn't going to join the stack with t...
hi , i have two files in my router flash .i have deleted one of the file named r1-confg. by checking the show flash status i found the file is present and in bracket it is mentioned as deleted .my question is what is the meaning of deleted here...
Hi,Two questions..it's posible management, inventory,etc.. switch 2960x/6509 vs-2T-10g, with cisco prime infraestructure 2.x?it's posible report with compliance licence switch 2960x?Thanks
Hi,I’m currently at a loss here:In our organisation we have multiple Nexus 5000 switches, which Cisco LMS 4.2.2 cannot get the running-config and startup-config from with the Archive Management process. When it does try to get them, I get a error as ...
Hi I useLMS 4.2, In fault Monitor I have the folowing messages : Event_DescriptionStateNotNormalDevice IP10.92.8.142Device TypeSwitches and HubsFault Last Updated At17-Nov-2013 12:36:25ComponentPWR-I@/2058 [Sw2, PS1 Faulty, RPS NotExist]Component Cla...
Hi all,on a new installed PI 1.2.1 I have the following error message as soon as I run a report:Failed to run report: Could not connect to HTTP invoker remote service at [http://localhost:20556/reportingserver/remoting/ReportingService-httpinvoker];...
Is there a function within Cisco Prime Infrastructure 2.0 (2.0.0.0.294) that will display the last time that an interface was active? Our end switch hardware is as follows C2960s-48fps and C3750-48PS-S. See below for command and command output from t...
Hello,I have a 3750 that should support temperature readings (WS-C3750G-48TS). In fact through CLI I can get the exact temperature:show env allFAN is OKTEMPERATURE is OKTemperature Value: 40 Degree CelsiusTemperature State: GREENYellow Threshold : 5...
If I want to run a cnr_shadow_backup on a PNR 8.1.3, are there any cnr_shadow_backup switches/flags I have to use to run it? I've just tried a bare cnr_shadow_backup and nothing seems to happen. Any suggestions?Eric Feldhusen
I have install LMS 4.2 and nat ip to discover found WS-6513 but cannot polling inventory.I serch for document about configuration on Network Devices such as switch, router, asa etc. to support LMS.But I cannot find it, anyone have example configurati...
Hello,I will monitor the wireless network for a few days and just that monitor traffic and document (utilization, who was on which AP connected ..)The wlan consists of a WLC 5508 APs and 50x 2602i.how can you find over time, how many and which wire...
Hi,is supported on C4900 EtherChannel Min-Links Feature? Or is there any alternative?I have three switches, connected in a triangle, each is connected with a second 2x10GbE in the EtherChannel.I want when one line in EtherChannel fails shutdown the e...
