Solved: Re: Technical Issue Meraki

ffatnass · ‎10-09-2023

Can we configure for some portforwards a geo location from where these portforwards are allowed.

With Layer 7 rules you can effectively set restrictions but then this is for both incoming and outgoing traffic and not just for that particular portforward

aleabrahao · ‎10-09-2023

Hi @ffatnass

It is not possible to apply geolocation to port forwarding.

You can only define specific IPs or the range of IPs that can reach the destination.

I am not a Cisco employee. My suggestions are based on documentation of Meraki best practices and day-to-day experience.

Please, if this post was useful, leave your kudos and mark it as solved.

View solution in original post

aleabrahao · ‎10-09-2023

Hi @ffatnass

It is not possible to apply geolocation to port forwarding.

You can only define specific IPs or the range of IPs that can reach the destination.

I am not a Cisco employee. My suggestions are based on documentation of Meraki best practices and day-to-day experience.

Please, if this post was useful, leave your kudos and mark it as solved.

ffatnass · ‎10-09-2023

Thank you so much for the quick response Alemabrahao!