Buy or Renew
Buy or Renew
cancel
Turn on suggestions
Auto-suggest helps you quickly narrow down your search results by suggesting possible matches as you type.
Showing results for 
Search instead for 
Did you mean: 
cancel
Start a conversation
626
Views
0
Helpful
1
Replies

3002 Client to PIX 515 w/v6.1 software

ROBERT CROOKS
Level 1
Level 1

‎10-17-2002 09:16 AM - edited ‎02-20-2020 10:18 PM

I have had conflicting reports and no success with enabling Network Extension Mode between these 2 devices. One consultant said that it was impossible to impliment, one said it was not even configurable with the firmware available, but Cisco says it does work. Has anyone used this combination?

Thanks

Robert Crooks c.Tech

Ivaco Rolling MIlls

0 Helpful
1 Reply 1

gfullage
Cisco Employee
Cisco Employee

‎10-21-2002 09:14 PM

There were a couple of bugs with this early on, with the 3002 sending the wrong netmask to build the tunnel, but this should definately work with PIX 6.2(2) and the latest code on the 3002.

0 Helpful
Customers Also Viewed These Support Documents
Review Cisco Networking for a $25 gift card