My envrionment consists of two ASA 5510 devices in active/passive failover, both v8.2(5).For years I have taken the easy way out to configure VPN access by using split-tunnel to give access to internal resources. Prior to the ASA I confugured my PIX'...

I'm struggling to address an issue where as a policy I have internal virtualized/clustered servers on reserved DHCP addresses on a separate VLAN, and occasionally there is a situation where by the guests change hosts and end up on another VLAN (for w...

I am looking some advise on what direction I should persue for an expansion to my network.Currently I have a Cat4506 chassis with a Sup II+ engine and one WS-X4232-RJ-XX linecard with the WS-U4504-FX-MT daughtercard to provide uplinks to four Cat2955...

I have been struggling to come up with the proper config to do a NAT of an incoming VPN tunnel to a VLAN on my network that I hope either someone has done or can shed some light on.I have an ASA 5510 with an IPSEC site-to-site tunnel to a partner net...