cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
1983
Views
5
Helpful
3
Replies

ACL not shown on ASDM

Hello, 

 

I have an ASA v9.12(4)10 and ASDM 7.12(2)14 

 

I have copied to it the configuration of a production ASA in order to replace it. 

 

I see that in cli the INSIDE interface ACL are present but in the ASDM are not shown. 

 

Any ideas?

 

Thanks and regards, 

Konstantinos

1 Accepted Solution

Accepted Solutions

@kostasthedelegate 

The command is access-group acl-name {in | out} interface <interface-name>

 

Example:- access-group OUTSIDE_IN in interface OUTSIDE

View solution in original post

3 Replies 3

Hi @kostasthedelegate 

The ACL might be visible via the CLI but it probably isn't attached to an interface, thats why it's not visible under the Access Rules page in ASDM.

 

HTH

Hello Rob, 

 

Thank you for the answer

Is there a way to attach it?

@kostasthedelegate 

The command is access-group acl-name {in | out} interface <interface-name>

 

Example:- access-group OUTSIDE_IN in interface OUTSIDE

Review Cisco Networking for a $25 gift card