Activating anyconnect on active/passive cluster

[Delmiro Campelo]

I have 50 premium anyconnect licenses that i need to install on a active/passive failover cluster, do i just need to activate it on the primary active ASA and not on the passive?

The command that I would use

activation-key key [activate | deactivate]

Example:

hostname# activation-key 0xd11b3d48 0xa80a4c0a 0x48e0fd1c 0xb0443480 0x843fc490

Are there any other special commands to have this license properly installed and shared in the cluster if the active asa fails? I appreciate the help.

Thanks!

[Julio Carvajal · Accepted solution]

Hello Delmiro,

Nop, that is all you need..

After 8.3(1) licenses are shared on a failover cluster,

So you should be good

Regards

[Delmiro Campelo]

Thank you

[Julio Carvajal]

My pleasure,

If you do not have any other question please mark it as an answered

Regards