AIP SSM w/ Failover

[rodrigo.cisco]

Hi all,

I will setup a module AIP SSM with failover active/standby. Did someone do this configuration? The active ASA will replicate the IPS config to the standby ASA? I look for some documentation on cisco site but I not found.

tks

[abinjola · Accepted solution]

Unlike ASAs..SSM Modules do not replicate there configs to each other..they are treated as separate units ..you have to manually confgure both the Modules

Refer..http://www.cisco.com/en/US/docs/security/ips/5.1/configuration/guide/cli/cliSSM.html#wpxref34736

See if this helps !

[rodrigo.cisco]

It`s very bad, because all config that I do in a module a will need to do the same config to each other... =(

But thank you a lot for you answer!!!

[michael.d.brown]

this is possible if you have csm - cisco security mgr