Buy or Renew
Buy or Renew
cancel
Turn on suggestions
Auto-suggest helps you quickly narrow down your search results by suggesting possible matches as you type.
Showing results for 
Search instead for 
Did you mean: 
cancel
Start a conversation
579
Views
0
Helpful
2
Replies

Analysis Engine not starting after 6.1 upgrade

mcvosi
Level 1
Level 1

‎05-15-2008 07:31 AM - edited ‎03-10-2019 04:06 AM

The Analysis Engine on my sensor is not starting after the upgrade to 6.1.

Also, when I use IDM to connect to the sensor it says:

Error connecting to sensor. Failed to create sensor - <IP address>.

Exiting IDM.

Labels:
0 Helpful
2 Replies 2

smahbub
Level 6
Level 6

‎05-21-2008 05:49 AM

Can you provide the output of commands "show tech" and "show version" which will help us in identifying the reason for the issue and resolving the same.

0 Helpful

avang2004
Level 1
Level 1

‎06-25-2008 05:57 AM

You might be running into this bug #CSCsm71528

Symptom:

After signature update or configuration change the AnalysisEngine shows NotRunning.

Conditions:

After a signature update or other configuration change.

Workaround:

None, to restore service reboot sensor.

0 Helpful
Customers Also Viewed These Support Documents
Review Cisco Networking for a $25 gift card