cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
545
Views
0
Helpful
1
Replies

Anyconnect and licensing

Setting up a Cisco 5555X with the following license:

Licensed features for this platform:
Maximum Physical Interfaces       : Unlimited      perpetual
Maximum VLANs                     : 500            perpetual
Inside Hosts                      : Unlimited      perpetual
Failover                          : Active/Active  perpetual
Encryption-DES                    : Enabled        perpetual
Encryption-3DES-AES               : Enabled        perpetual
Security Contexts                 : 2              perpetual
GTP/GPRS                          : Disabled       perpetual
AnyConnect Premium Peers          : 2              perpetual
AnyConnect Essentials             : 5000           perpetual
Other VPN Peers                   : 5000           perpetual
Total VPN Peers                   : 5000           perpetual
Shared License                    : Disabled       perpetual
AnyConnect for Mobile             : Enabled        perpetual
AnyConnect for Cisco VPN Phone    : Disabled       perpetu

Im seeing in the config that I can limit the "Maxium Anyconnect Sessions", this is set to "1" and I cannot change it. Im wondering if Im missing something or if I can ignore this. I cannot test before I swap with a old ASA.

Thanx.

Please rate as helpful, if that would be the case. Thanx
1 Accepted Solution

Accepted Solutions

Philip D'Ath
Meraki Community All-Star
Meraki Community All-Star

You have 5,000 AnyConnect Essential licences, which is the licence to use the thick AnyConnect client.  You don't need "AnyConnect Premium Peers" unless you want to use a clientless configuration.

If it is something else, post the actual bit of config with the issue.

View solution in original post

1 Reply 1

Philip D'Ath
Meraki Community All-Star
Meraki Community All-Star

You have 5,000 AnyConnect Essential licences, which is the licence to use the thick AnyConnect client.  You don't need "AnyConnect Premium Peers" unless you want to use a clientless configuration.

If it is something else, post the actual bit of config with the issue.

Review Cisco Networking for a $25 gift card